[dCiSo]

INFECTUS TEAM - ARGON SPI - 9 WIRES FIRMWARE 1.1

Finally we are back with the correct 9 wires update! (This time full tested with about 15 beta users arround the world)

Download it here: http://www.infectus.biz/downloads/WASABUS-argon-1.1.zip

In this ZIP fill you will find these things:
1- INFECTUS PROGRAMMER, beta version to manage correctly ARGON SPI update
2- wasabus_argon.bin, this is the firwmare that is necessary to flash inside the SPI flash of ARGON
3- wasabus_a125argon-1.1.dat / wasabus_a250argon-1.1.dat, these are the new ACTEL firmware to support 9 wires installation

Please read "PROCEDURE TO PROGRAM ARGON SPI.DOC" for update your argon correctly to 9 wires.
IMPORTANT: Don't connect injectus when modchip is working in the wii console, with injectus connected argon is unstable.

The only difference between previus diagram is the bridge necessary between C and D pads of argon, both connected then to C point on motherboard... check diagram in the zip file.
WASABUS debug LEDS:

The LED on the ARGON will show you if modchip is correctly working or not, is very simple
LED OFF = Don't works
LED ON = Code injection procedure is complete
REGIONAL SETUP:
Current firmware is setup by default like PAL.

To setup the other region just shortcut the pads W and R in this way:
Both to GND = modchip OFF
W to GND = JAP
R to GND = USA

Note: injectus don't works anymore in this version like configurator with switches and leds, for a problem develope. We are working on that. If there are problems with modchip we suggest to don't connect injectus when modchip is working in the console.

------
THANX FOR ALL
INFECTUS TEAM